Autoterm 4D floor mounting bracket 20 x 20 x 8 cm

The floor mounting bracket will allow you to easily install the Autoterm Air 4D forced air heater in the floor by making a cutout in your floor, even if you have insulation and wood, thus saving more space in motorhomes, caravans, boats.

The floor mounting bracket can be sealed tightly if necessary.

The heater is mounted on top of the bracket (the gasket is already mounted on the unit), thus hiding the fuel pump connection, exhaust outlet and air intake, which are found thus protected by the sides of the support, already below the vehicle and avoiding any risk of fire.

Once the support is embedded in your floor, sandwiching your insulation, the floor and the vehicle's sheet metal, all you have to do is bolt the heater to the underside of your vehicle and connect the exhaust pipe to it. and air intake, as well as the diesel inlet.

The floor mounting bracket is made of 316 stainless steel.

Top: 200 x 200 x 2 mm

Bottom: 104 x 104 x 80 mm

Exhaust / air intake: Ø 30 mm

Screw: Ø 6 mm

Also compatible with Autoterm Air 2D heaters.