autoterm 2D heating assembly box

Accessories included:

1 x stainless steel mounting box

1 x rubber fitting (AT0048)

2 x flange (P4931)

This box is compatible with the following references:

Universal mounting bracket (AT0019)

Mounting Box Bracket Kit (AT0047)

Installation advice: If you install your heater under the chassis of the vehicle, we advise you to put ducting at both ends of the heater (inlet/outlet), to suck air into the interior of the vehicle (not outside ): to avoid sucking in exhaust gases (wind), and because the heating power is dependent on the air flow. The air flow must be maximum so that the heating can reach these 2000 watts for a 2D (4000 watts for a 4D).